Automated climate control with two fans - for 6m³

Automated (regulated by temperature) ventilation kit. Two fans (for intake and exhaust) are controlled simultaneously to remove used-up and overheated air and provide fresh air.

This assembly set (DIY) is best suited for grow rooms or grow tents with up to 6 m³ of volume.

Assembly instructions:

1. First you need two holes in the greenhouse walls for the flanges (many grow tens already got holes). Normally the hole for intake is on the cooler side (shaded/sun-protected), extake should be planned on the side where the consumed air (and the noises originating from the outlet) annoy least.
2. Insert flanges (from outside) and fix them.
3. Determine the proper length for your air tubes (you should plan the whole construction with exact measurements on paper before starting) and cut them to the right length, then push them through the flanges (from inside) and connect flange and tube.
4. Connect the first fan with the power cable.
5. Affix easy rolls on roof or suspension. Connect the fan with the Easy Rolls (the fan has screws for fastening, you have to loosen on and insert the line of the easy roll, the screw it fast again).
6. Connect hose and fan (use the hose clamp).
7. Same with the second fan.
8. Install the SMSCom TwinController on a secure and accessibly place.
9. Plug in the fans into the Controller's outlest by observing the TwinController Instructions.
10. Plug-In the TwinController
11. DONE

• 1 x SMSCom TwinController
• 1 x LTI Fan 100mm: 180 m³/h
• 1 x LTI Lüfter 125mm: 225 m³/h
• 2 x PVC Power Cord
• 2 x Easy-Rolls for suspension
• 1m Combi duct hose, 102 mm
• 1m Combi duct hose, 127 mm
• 4 x duct hose clamp
• 1 x wall flange, 100 mm
• 1 x wall flange, 125 mm