The Piecemaker is a high quality press of stainless steel. Hardly any wear and tear.
The pressure of max. 3.000kg compresses the resin without a rest humidity. You can put your own logo or pattern onto the final product with a stemp (not included). Make your own piece!
What is a Piecemaker?
The
Piecemaker is a precisely manufactured compression-press made of food-safe high-grade steel. .
The extremely hard X10CrNis189 stainless steel has been used for the
Piecemaker to avoid abrasion (high pressure warp resistant - abrasion-proof thread)
The rolled thread made from the same type of stainless steel provides for an incredible 3,000 kg pressure (at maximum).
Due to the Piecemaker' patented design (reg. no. 210313) an optimal heat supply is possible before or during the pressing process without deteriorating the material.
No material is wasted due to the tenth-of-a-millimeter-exact fit. It only needs two simple movements to take the the
Piecemakerapart for cleaning.
Warum sollte man den Piecemaker verwenden?
Pressing with the
Piecemaker means to use heat and pressure to compress the material into one 'piece'. Through this process the remaining moisture is removed and the density (important for the rate of combustion) is determined. The
Piecemaker also makes transport and consumption a lot easier.
By using state-of-the-art screening methods (for example, Pollinator or Ice-O-Lator) everyone can produce highest-quality resin powder today that can be further processed with the
Piecemaker.
To avoid impurities in the material gentle pressing is a must. Ideal is the
Piecemaker since the pressure can be easily controlled.
Gentle mechanical pressing is the only way to provide for a crusty surface, which protects the material from oxidation and consequently also from the decay of the active agent.
When resin is pressed without too much heat exposure (the most efficient way is to use a hairdryer) hardly any resin glands will burst and the natural colouring of the high-quality crystals won't change.
However, gentle heat of 75° celsius maximum is required, since fresh THC contained in the material comes as acid and, in its chemically neutral form, needs to be activated to take the desired psychoactive effect.
TIP: If your pressed piece is brittle you probably used too much heat and/or pressure. That'll never happen with the
Piecemaker!